Puma air compressor repair parts full#

If they’re not, move the points so they are no longer in contact by bending the cicular spring flat. To adjust it, make sure the points on the contact plate of the switch are in open position. If you’re comfortable and have relative knowledge of centrifugal switches, you can adjust or replace it yourself. Therefore, it is imperative to conduct a check on the centrifugal switch and make sure it’s operating sufficiently.

Puma air compressor repair parts full#

And if this happens, the start windings are unable to withstand the heat of the compressor’s full RPM, which will cause the compressor to overheat, tripping the reset button. If the centrifugal switch gets stuck in the open position, the windings will not shift properly. Over time, the centrifugal switch can begin to shift out of adjustment, which causes it to get stuck in one position. Once the compressor motor reaches about ¾ of its RPM, it switches gears from the start motor windings to the run windings. If you think about a car, the centrifugal switch is like first gear, It energizes the start-up windings. The centrifugal switch is activated by a force caused by a rotating shaft (usually a gas engine or electric motor). The majority of air compressors have what a part called the centrifugal switch. For information on an air compressor tripping the breaker on the restart, visit our article here!

Isn’t it so frustrating when you have a fully loaded air tank and you begin operating the air tool, and as the pressure starts to build, the air compressor suddenly trips the circuit breaker and the reset switch is good for absolutely nothing? This page will help you fix these issues. If your air compressor reset button keeps tripping, it’s probably because your air compressor is too hot. If the button is tripping then the motor is already getting hot. If a compressor were to overheat without the presence of a reset button, the motor will become damaged and lead to serious problems down the line. Its main purpose is to automatically turn off the air compressor’s power when it overheats. The reset button is there to provide the user with safety. In some cases, it may be located inside the wiring of the motor. An air compressor’s reset button, otherwise known as the thermal overload button or safety switch, is located on the end of the air compressor or on its side.